Black Box ET1000A Manuel d'utilisateur télécharger pdf (Page 15)

Installation Examples

EncrypTight Manager Installation Guide 15

Ordering of actions is important.

You should install in the following steps:

1 Power on both servers

2 Assign IP to server #1

3 Assign IP to server #2

4 Make sure that server #1 can see server #2 on the network

5 Run /etc/init.d/policyserver-install on server #1 ( same order of IP addresses on both )

6 IMPORTANT: WAIT for server #1 to fully complete the install and startup

7 Run /etc/init.d/policyserver-install on server #2 ( same order of IP addresses on both )

Once installation is complete you can view the web interface from either of the cluster nodes IP

addresses.

To verify that the cluster is in place check the Platform -> Utilities page DB Nodes and Appserver Nodes.

Disaster Recovery Install

Using Single Server For Main Site

Main Site

• Assign an IP to the Main site installation.

• Modify the /opt/scripts/policyserver-init.conf and set the following. Emacs, nano, and vi are available

on the OS.

NOTE

The disasterHost IP should be the IP of the Disaster Recovery server.

########################################################################

#######

####### Disaster Recovery options

#######

## When this

server will use a disaster recovery site set the following:

heartbeatEnabled=true

disasterEnabled=true

disasterHost=192.168.80.X - THE IP OF THE DISASTER RECOVERY SERVER

disasterUser=pserver

disasterPass=pserver

heartbeatPort=8764

## When this

server IS the disaster recovery site set the following:

# disasterServer=true

# disasterServerUser=admin

# heartbeatInterval=30000

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Pas de commentaire

Black Box ET1000A Manuel d'utilisateur Page 15