Black Box LE1502A Guide de l'utilisateur télécharger pdf (Page 39)

BLACK BOX



Media Converters Installation and User Guide (01/02)

1. Using standard 10BASE-T media, insert either end of the cable with an RJ-45

plug into the RJ-45 connector of the Black Box Media Converter.

2. Connect the other end of the cable to the corresponding device.

3. Use the LINK LED to ensure proper connectivity by noting that the LED will be

illuminated when the unit is powered and proper connection is established. If the

LINK LED is not illuminated, change the setting of the up-link switch (See

Section 4.4 for up-link switch information.) If this does not help, ensure that the

cable is connected properly and is not defective.

4. For the xxxxxLP model with the Link-Pass-through feature. The two LINK

LEDs operate together, and either both LEDs are lit or neither is lit. Both of the

attached cables must be operate for LINK to be indicated. Absence of LINK does

not point to the problem cable segment, and the fault may be in either.

3.3.2 Connecting ThinNet 10BASE2

Connect the ThinNet coax cable to the BNC connector on the Black Box Media

Converter in the same manner as is done for any standard BNC connection. Be sure that

the BNC segment is properly terminated using a standard “T” connector and terminator.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 50 51

Pas de commentaire

Black Box LE1502A Guide de l'utilisateur Page 39