Black Box TS255A Spécifications télécharger pdf (Page 42)

Major features

Chapter 4 Aggregator TAPs

rev. 1

Major features

An Aggregator TAPs provides a full-duplex pass through link for the

connection being monitored. The TAP integrates both sides of the

full-duplex link and sends the copied data out simplex (send only)

ports to two analyzers. The Aggregator TAPs also provide a buffer

(256 MB, 512 MB, or 1 GB) to protect against the packet loss that

could otherwise result from traffic spikes where more data enters the

TAP from the network than can be sent to the analyzer. These are the

Aggregator TAPs:

 Copper Aggregator TAP

The major features of the Black Box TAPs are:

 Passive access at 10/100/1000 Mbps without packet

tampering or introducing a single point of failure

 No packet loss if the TAP loses power

 Automatic link failover for devices that have an alternate path

 Allows you to connect and disconnect the analysis device as

needed without taking the network down

 Optional redundant power ensures maximum monitoring

uptime

 All traffic (including errors) is passed from all OSI layers for

troubleshooting

 Enhanced security because the TAP does not require or use an

IP address, which makes it, and the analyzer connected to it,

impervious to viruses and other attacks

 LEDs show power and link status

 Optional 19-inch rack frames hold up to 3 TAPs

 Front-mounted connectors make installation simple

 Fully IEEE 802.3 compliant

 Fully RoHS compliant

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 63 64

Pas de commentaire

Black Box TS255A Spécifications Page 42