Black Box TS255A Spécifications télécharger pdf (Page 45)

Installing the Copper Aggregator TAP

Chapter 4 Aggregator TAPs

rev. 1

Figure 9 Bandwidth utilization that a buffer can absorb on a gigabit network

Installing the Copper Aggregator TAP

After reviewing the information in “Deciding whether to use a TAP or

a SPAN/mirror port” on page 8 and “Choosing between a SPAN,

Aggregator, or full-duplex TAP” on page 10, you decided an Copper

Aggregator TAP was the right one for you. Use the information in this

section to install your TAP.

To install the Copper Aggregator TAP, you must:

 Decide where to place the TAP, and physically mount it, if

desired. This will be in a PC drive bay, rack mount bracket, or

wherever it is most convenient. For efficient heat dissipation,

keep the TAP horizontal.

 Use standard Ethernet cables with RJ-45 connectors to

complete the pass-through connection between the device of

interest and the network. See “Choosing crossover or straight-

through cables” on page 57.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 63 64

Pas de commentaire

Black Box TS255A Spécifications Page 45