Black Box TS255A Spécifications télécharger pdf (Page 55)

How do I connect my failover devices?

Chapter 5 FAQ and Troubleshooting

rev. 1

C Choose the “Team with other adapters” option and then click

New Team... to start the New Team Wizard. The first dialog

lets you name the Team (you may want to call it something

like “Virtual Dual-receive”).

D Click Next and add another adapter/port that supports

teaming (for example the second port on a dual-port IntelPro

card).

E Click Next and choose Static Link Aggregation. This option

works best for aggregating both sides of a full duplex link for

analysis. Click Next, and then Finish. The My Network Places

display should now list the new virtual adapter.

How do I connect my failover devices?

When the device connected to Link B fails, the TAP disables Link A

so that the device on Link A can initiate its failover procedure. The

TAP then restarts its search phase. Until the Link B device is working

again, the TAP repeats the following steps:

A Search.

B Determine if Link A is up. If not, keep searching.

C If Link B is up, then re-establish the connection. If Link B is

still down, then shut down Link A.

D Go to Step A.

Figure 14 Cabling Failover Devices

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

Pas de commentaire

Black Box TS255A Spécifications Page 55