Black Box WAP-300BGN Spécifications télécharger pdf (Page 49)

724-746-5500 | blackbox.com

Page 48

11N 2T2R Wireless Access Point

Input the current password in Current Password field, then input a new password in both the New Password and the Re-Enter

Password field. After you finish, go to the bottom of this page and click on the Apply button. The following message will be dis-

played:

Figure 3-46. Settings saved successfully prompt.

When you see this message, the settings you made are successfully saved. Click on the Continue button to go back to the previ-

ous page and continue setting other items. Click on the Apply button to restart the wireless access point. The changes will take

effect after about 30 seconds.

3.10.2 IP Address of the Wireless Access Point

You can change the IP address of this wireless access point, so it can become a part of your local network. Remember this

address or you will not be able to connect to this wireless access point’s configuration menu.

The default IP address is: 192.168.2.1/subnet mask 255.255.255.0. Press and hold the Reset/WPS button for more than 10 sec-

onds to change the IP address back to the default value if you forget the IP address you set.

To change the IP address, click System Utility on the left, and the following screen will be displayed:

Figure 3-47. Management IP screen.

Input the IP address and the Subnet Mask in the corresponding fields. To manage this wireless access point from another network

(such as the Internet), input the IP address of the gateway in Gateway Address field.

To activate the wireless access point’s DHCP server, select Enabled in the DHCP Server option, and see Section 3.10.3 for detailed

instructions. If you don’t want to use the wireless access point’s DHCP server function, or if there’s another DHCP server on the

network that this access point connects to, select Disable.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 58 59

Pas de commentaire

Black Box WAP-300BGN Spécifications Page 49