Black Box Multi-Function Line Driver Manuel d'installation télécharger pdf (Page 30)

3. SETTING UP THE EQUIPMENT

3-8

Menu Initial Setup (Data Damping)

Menu Initial Setup (Browser Installation)

3.3 How to Set up the Radar

If you have a radar sensor, set the sensor’s characteristics on the [Radar] menu. Open

the [Menu Radar] sub menus. Drag the main menu to select [Radar].

1. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type

connected.

Note: If a DRS sensor is connected but does not appear in the [Radar Source] list,

close the list and open it again. The name of the DRS sensor should appear with

a check mark, as in the example below.

Menu item Description Options (setting range)

[COG & SOG] Set data damping time. The lower the set-

ting the faster the response to change.

0 to 59 seconds

[Heading]

[Speed Through Water]

[Wind Speed & Angle]

[Rate of Turn]

Menu item Description Option (setting range)

[FAX30 Browser] Show the Facsimile Receiver FAX-30 display.

[FA30 Browser] Show the AIS Receiver FA-30 display.

[FA50 Browser] Show the AIS Receiver FA-50 display.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Pas de commentaire

Black Box Multi-Function Line Driver Manuel d'installation Page 30