Black Box LWN600CM-1 Guide de l'utilisateur télécharger pdf (Page 100)

724-746-5500 | blackbox.com

Page 100

724-746-5500 | blackbox.com

Chapter 8: Basic Configuration Examples

SmartPath EMS VMA begins transferring the configuration to SmartPath AP3 and displays the Monitor > Access Points >

SmartPath AP Update Results page where you can observe the progress and the result of the operation.

AfterSmartPathAP3rebootstoactivateitsnewconfiguration,ittriestoreconnectwithSmartPathEMSVMA.However,itcan-

not do so because it is a mesh point that now belongs to the cluster1-test cluster while its portals—SmartPath AP1 and 2—are

still using their original configurations in which they are members of cluster0. This loss of connectivity will continue until you

update the portals, which you do next.

5. Repeat the previous steps to update SmartPath AP1 and SmartPath AP2.

After they reboot and activate their new configurations, check the status of their CAPWAP connections by looking at the

CAPWAP column on the Monitor > Access Points > SmartPath APs page with the View mode set as Monitor. After a few

minutes, all three SmartPath APs will reestablish their connections.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 191 192

Pas de commentaire

Black Box LWN600CM-1 Guide de l'utilisateur Page 100