Black Box IC108A Guide d'installation télécharger pdf (Page 12)

ISC Communications

154 —

revision 1

After the firmware upgrade has been completed, disable port 77FE to prevent unauthorized access to this

device.

Otherwise, the device should show up in DeviceInstaller. To upgrade the firmware:

1. Select the device. The line will be highlighted.

2. Click [Upgrade].

3. The Device Upgrade Wizard will appear. Select Create a custom installation by specifying individual

files. Click [Next].

4. Enter the path for the downloaded firmware by either typing it in or clicking [Browse...]. Click [Next].

5. If you wish to upgrade the internal Web Server, select Install files contained in COB partitions.

If you do NOT wish to upgrade the internal Web Server, select Do not copy or replace any files and

proceed to step

Click [Next].

a. Select the partition number and click [Set Partition...].

b. Locate the .cob file. Click [OK].

c. Click [Next].

6. You may save this installation for later use, if you wish, by clicking [Save Installation...]. This is

particularly useful for upgrading multiple devices.

7. Click [Next] to begin updating the device. A status bar indicates the progress of the update.

8. After the update completes successfully, the device will reboot and there will be a temporary loss of

communication to the ISC.

9. Click [Close].

• If communications are not restored, power down the ISC for at least 10 seconds, then power it up

once again.

Upgrading the Firmware via TFTP

1. Before upgrading, verify communication with the device. At the command prompt, type:

ping <IP address>

2. To upgrade the firmware, type:

tftp-i <ip address> put <firmware source> 3L

For example: tftp-i 10.112.5.92 put d:\lantronix\micro\ltx5801.rom 3L

3. After the update completes successfully, the device will reboot and there will be a temporary loss of

communication to the ISC.

4. If you wish to upgrade the internal web interface, type:

tftp-i <ip address> put <internal web interface> WEB6

For example: tftp-i 10.112.5.92 put d:\lantronix\micro\cbx360.cob WEB6

5. Upon successful upgrade, a confirmation message will be displayed.

30.4.4 Troubleshooting Micro 100 Products

There may be a problem with the latest version of the on-board Ethernet devices for the LNL-500 and LNL-

2000. A change was made to the device during production that will cause the following problems. This

applies to the LNL-ETHLAN-MICR ONLY. It does not apply to the older 10 MB version of the units, only

the latest units that are 10/100 MB and have been shipping since March 2004.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Commentaires sur ces manuels

Pas de commentaire

Black Box IC108A Guide d'installation Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Black Box IC108A