Black Box IC108A Guide d'installation télécharger pdf (Page 3)

Hardware Installation Guide

revision 1 — 145

5. At this point, press the <Enter> key. (It may take a few seconds to complete booting).

• Power should be cycled to the device while connected to it in order to see the “Load Completed...”

message.

• If it appears that nothing changes after pressing the <Enter> key, it is possible that the Lantronix

MSS1 or MSS100 device was already configured once. If this occurs, you need to press the

<Enter> key before the phrase, “Load Completed-Boot in Progress” appears. If this still does not

allow you to enter into the command mode, you may also telnet into the Lantronix device.

• If the device was configured previously, it may be best to do a hard reset and configure it from

scratch. To do this:

a. Using the end of a paper clip, or a similar small object, hold down the reset button.

b. Cycle power to the device.

• A prompt that says Local_1> should appear. If the prompt says Boot>, then the Ethernet

Address has not been defined and you must enter one.

a. At the Boot> prompt, type:

change hardware n

where n represents the last three digits of the Ethernet Address located on the bottom of the

Lantronix box (Example: change hardware 21-01-65).

b. Reboot for the change to take effect.

c. Wait for it to finish loading. Once it’s done, you should see a screen resembling the picture on

the previous page.

6. You will be prompted for a user name. Enter any name.

30.2.2 Establishing Network Communications

After a factory default reset, the following changes must be made:

1. At the prompt, type:

set privileged and press <Enter>.

2. Type in the password:

system and press <Enter>.

3. Determine and set the IP address. Type:

change ipaddress [IP ADDRESS] and press <Enter>.

4. Set the Gateway. Type:

change gateway [GATEWAY] and press <Enter>.

5. Set the boot flags. Type:

change bootp disabled and press <Enter>

change dhcp disabled and press <Enter>

change rarp disabled and press <Enter>

6. Set the access type to remote. Type:

change access remote and press <Enter>

7. At the prompt, type:

logout and press <Enter>.

8. Exit from HyperTerminal and cycle power to the device.

1 2 3 4 5 6 7 8 ... 34 35

Pas de commentaire

Black Box IC108A Guide d'installation Page 3